3 seconds later, the LCD will display this sequence, hh:mm (hour:minute) ➔ mm:dd (month:dayJ ➔ yyyy (year)➔ Photo count. When the camera is switched ON, at any point of time, press the+ navigation button. Viewing the current time, date and photo count: If no key is pressed far 30 seconds, the LCD will turn off. When the green LED flashes 3 times, the LCD will shaw the acquired time. Whenever there is a single flash of the green LED and it goes off for 60 seconds, it means the RCC signal is being acquired. When the month is set, repeat steps 1 and 2 set the day and year. Press the OK navigation button after setting the minute to change the dateģ. When the hour is set, repeat steps 1 and 2 to set the minutes. Press the + navigation button to go up in sequence.ģ. To change time, start by pressing and releasing the OK navigation button to set the hour.Ģ. While the camera is switched on, if the OK button is pressed then the LCO will light up. Note: It generally takes anywhere from 3 to 30 minutes to lock the signal and set time and date. After 30 seconds, the LCD is turned off and the camera automatically enters the RCC signal search mode. When the camera is powered on for 3 seconds, the LCD will display the factory default (incorrect) time. The power indicator will flash a green light once. Turn on the camera’s power switch, and then slide the switch la Photo or Video mode to turn it on. Slide the latch lo select your delay setting.ĭelay is the time for the camera to take the next photo or video after 5 seconds, 1 O seconds, 15 seconds.ġ. M – On behalf of the Mountain, the time after the camera successfully receives the RCC signal will be reduced by 7 hours from the time set an the signal transmitter UTC -7hrĬ – On behalf of the Central region, the time after the camera successfully receives the RCC signal will be reduced by 6 hours Imm the time set an the signal transmitter UTC -6hrĮ – On behalf of the Eastern region, the time after the camera successfully receives the RCC signal will be reduced by 5 hours Imm the time set an the signal transmitter UTC-5hrġ. P – On behalf al the Pacific region, the time after the camera successfully receives the RCC signal will be reduced by 8 hours Imm the time set an the signal transmitter UTC -8hr Slide the latch ta set your time zone first. New cards are ok to use straight from the package. If you are using an SD card from other cameras, please make sure to format the SD card in your computer prior to use in your camera. Make sure the camera is powered off before removing or installing an SD card. Load SD memory card (up to 32GB) into the SD card slot with the connectors lacing dawn. Push battery compartment in and slide the latch to the left (lacked icon) ta secure the batteries.įlashing red LED indicates law battery. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nicad, ni-mh, etc) batteries.Ĥ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |